3com MSR 20-20 참조 매뉴얼
1129
Total Nets: 2
Intra Area: 1
Inter Area: 1
ASE: 0
NSSA: 0
display ospf vlink
Syntax
display ospf [ process-id ] vlink
View
Any view
Parameters
process-id: OSPF process ID, in the range 1 to 65535.
Description
Use the display ospf vlink command to display OSPF virtual link information.
If no OSPF process is specified, the OSPF virtual link information of all OSPF
processes is displayed.
processes is displayed.
Examples
# Display OSPF virtual link information.
<Sysname> display ospf vlink
OSPF Process 1 with Router ID 3.3.3.3
Virtual Links
Virtual-link Neighbor-ID
-> 2.2.2.2, Neighbor-State: Full
Interface: 10.1.2.1 (Serial2/0)
Cost: 1562
State: P-2-P
Type: Virtual
Transit Area: 0.0.0.1
Timers: Hello 10 , Dead 40 , Retransmit 5 , Transmit Delay 1
Table 276 Description on the fields of the display ospf routing command
Field Description
Destination Destination
network
Cost Cost
to
destination
Type
Route type: intra-area, Transit, stub, Inter-area, Type1 External,
Type2 External.
Type2 External.
NextHop Next
hop
address
AdvRouter Advertising
router
Area Area
ID
Total Nets
Total routes
Intra Area
Total intra-area routes
Inter Area
Total inter-area routes
ASE Total
ASE
routes
NSSA
Total NSSA routes
Table 277 Description on the fields of the display ospf vlink command
Field Description
Virtual-link Neighbor-id
ID of neighbor connected to the router via the virtual link
Neighbor-State
Neighbor State: Down, Attempt, Init, 2-Way, ExStart, Exchange,
Loading, Full.
Loading, Full.
Interface
Local interface’s IP address and name of the virtual link