3com MSR 20-20 참조 매뉴얼

C

HAPTER

 77: RIP C

ONFIGURATION

 C

OMMANDS

process-id: RIP process number, in the range of 1 to 65535. The default is 1.

vpn-instance vpn-instance-name: Specifies a VPN instance name, a string of 1 to 
31 characters.

Use the rip command to create a RIP process and enter RIP view.

Use the undo rip command to disable a RIP process.

By default, no RIP process is enabled.

Note that:

■

If no VPN instance is specified, the RIP process will run under public network 
instance.

■

You must create a VPN instance before you apply a RIP process to it. For related 
configuration, refer to “ip vpn-instance” on page 1696.

■

You must create the RIP process before configuring the global parameters. This 
rule does not apply to interface parameters.

■

The configured interface parameters become invalid after you disable the RIP 
process.

# Create a RIP process and enter rip process view.

<Sysname> system-view

[Sysname] rip

[Sysname-rip-1] 

rip authentication-mode { md5 { rfc2082 key-string key-id | rfc2453 key-string } | 
simple password }

Interface view

md5: MD5 authentication mode.

rfc2453: Uses the message format defined in RFC 2453 (IETF standard).

rfc2082: Uses the message format defined in RFC 2082.

key-id: MD5 key number, in the range of 1 to 255.

key-string: MD5 key string with 1 to 16 characters in plain text format, or 1 to 24 
characters in cipher text format. When the display current-configuration 
command is used to display system information, a 24-character cipher string is 
displayed as the MD5 key string.

simple: Plain text authentication mode.