3com MSR 20-20 참조 매뉴얼

C

HAPTER

 2: IMA-E1/T1 I

NTERFACE

 C

ONFIGURATION

 C

OMMANDS

By default, IMA group interface test is disabled.

Note that:

■

If you do not specify the number argument, the ima-test command specifies 
to test the link that is the first to be added to the IMA group interface.

■

If you do not specify the id argument when executing the ima-test command, 
the default test mode (that is, 0xAA) is adopted.

■

You can use this command to test the connectivity of a link to the rest of the 
IMA group by sending a test pattern over the link. This test mode is looped 
over all the active links at the far end and back to the transmitter. To display the 
connectivity test result, perform the display interface ima-group command.

n

# Send test mode 0xAB over link 0 in IMA group interface 1.

<Sysname> system-view

[Sysname] interface atm 5/0

[Sysname-Atm5/0] ima ima-group 1

[Sysname-Atm5/0] interface ima-group 5/1

[Sysname-Ima-group5/1] ima-test link-number 0 pattern-id ab 

interface ima-group group-interfacenumber

System view

group-interfacenumber: IMA group interface number.

Use the interface ima-group command to enter IMA group interface view.

# Enter IMA group interface 1 view.

<Sysname> system-view

[Sysname] interface atm 5/0

[Sysname-Atm5/0] ima ima-group 1

[Sysname-Atm5/0] quit

[Sysname] interface ima-group 5/1

[Sysname-Ima-group5/1] 

loopback { cell | local | payload | remote }

ATM E1/T1 interface view