3com MSR 20-20 참조 매뉴얼
1266
C
HAPTER
82: IP
V
6 BGP C
ONFIGURATION
C
OMMANDS
Description
Use the synchronization command to enable the synchronization between IPv6
BGP and IGP.
BGP and IGP.
Use the undo synchronization command to disable the synchronization.
The feature is disabled by default.
With this feature enabled and when a non-BGP router is responsible for
forwarding packets in an AS, IPv6 BGP speakers in the AS cannot advertise routing
information to other ASs unless all routers in the AS know the latest routing
information.
forwarding packets in an AS, IPv6 BGP speakers in the AS cannot advertise routing
information to other ASs unless all routers in the AS know the latest routing
information.
By default, upon receiving an IPv6 IBGP route, the BGP router only checks whether
the next hop is reachable before advertisement. If synchronization is enabled, the
IBGP route can be advertised to EBGP peers only when the route is also advertised
by the IGP.
the next hop is reachable before advertisement. If synchronization is enabled, the
IBGP route can be advertised to EBGP peers only when the route is also advertised
by the IGP.
Examples
# Enable the route synchronization between IPv6 BGP and IGP.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] synchronization
timer (IPv6 address family view)
Syntax
timer keepalive keepalive hold holdtime
undo timer
View
IPv6 address family view
Parameters
keepalive: Keepalive interval in seconds, ranging from 1 to 21845.
holdtime: Holdtime interval in seconds, ranging from 3 to 65535.
Description
Use the timer command to specify IPv6 BGP keepalive interval and holdtime
interval.
interval.
Use the undo timer command to restore the default.
By default, the keepalive and holdtime intervals are 60s and 180s respectively.
Note that:
■
Timer configured using the peer timer command is preferred to the timer
configured using the timer command.
configured using the timer command.
■
The holdtime interval must be at least three times the keepalive interval.
■
The configured timer applies to all the IPv6 BGP peers. It becomes valid only
after the corresponding IPv6 BGP connections are reset.
after the corresponding IPv6 BGP connections are reset.