3com MSR 20-20 참조 매뉴얼

C

HAPTER

 83: IP

V

6 IS-IS C

ONFIGURATION

 C

OMMANDS

IS-IS view

None

Use the ipv6 enable command to enable IPv6 for the IPv6 IS-IS process.

Use the undo ipv6 enable command to disable IPv6.

IPv6 is disabled by default.

To run IPv6 IS-IS, you need enable global IPv6 capability, create an IS-IS process 
with the isis command, set a NET for the router with the network-entity 
command, then use the ipv6 enable command to enable IPv6 for the process, 
finally use the isis ipv6 enable command on relevant IS-IS interfaces to enable 
IPv6 for them.

# Create IS-IS routing process 1, and enable IPv6 for the process.

<Sysname> system-view

[Sysname] ipv6

[Sysname] isis 1

[Sysname-isis-1] network-entity 10.0001.1010.1020.1030.00

[Sysname-isis-1] ipv6 enable 

ipv6 filter-policy { acl6-number | ipv6-prefix ipv6-prefix-name | route-policy 
route-policy-name } export [ protocol [ process-id ] ]

undo ipv6 filter-policy export [ protocol [ process-id ] ]

IS-IS view

acl6-number: Number of a basic or advanced IPv6 ACL used to filter redistributed 
routes before advertisement, ranging from 2000 to 3999. Refer to “IPv6 ACL 
Configuration Commands” on page 2103 for ACL information.

ipv6-prefix-name: Name of an IPv6 prefix list used to filter the redistributed routes 
before advertisement, a string of 1 to 19 characters. Refer to “IPv6 Routing Policy 
Configuration Commands” on page 1213 for IPv6 prefix list information.

route-policy-name: Name of a routing policy used to filter the redistributed routes 
before advertisement, a string of 1 to 19 characters. Refer to “Routing Policy