3com MSR 20-20 참조 매뉴얼
1294
C
HAPTER
84: IP
V
6 OSPF
V
3 C
ONFIGURATION
C
OMMANDS
area-id: The ID of an area, a decimal integer (in the range of 0 to 4294967295)
that is translated into IPv4 address format by the system or an IPv4 address.
that is translated into IPv4 address format by the system or an IPv4 address.
Description
Use the display ospfv3 topology command to display OSPFv3 topology
information. If no process is specified, topology information of all OSPFv3
processes is displayed.
information. If no process is specified, topology information of all OSPFv3
processes is displayed.
Examples
# Display OSPFv3 area 1 topology information.
<Sysname> display ospfv3 topology area 1
OSPFv3 Process (1)
OSPFv3 Area (0.0.0.1) topology
Type
ID(If-Index)
Bits
Metric
Next-Hop
Interface
Rtr
1.1.1.1
--
Rtr
2.2.2.2
1
2.2.2.2
Eth1/0
Rtr
3.3.3.3
1
3.3.3.3
Eth1/0
Rtr
4.4.4.4
1
4.4.4.4
Eth1/0
Net
4.4.4.4(983049)
1
0.0.0.0
Eth1/0
display ospfv3 vlink
Syntax
display ospfv3 [ process-id ] vlink
View
Any view
Parameters
process-id: Specifies the ID of an OSPFv3 process, ranging from 1 to 65535.
Description
Use the display ospfv3 vlink command to display OSPFv3 virtual link
information. If no process is specified, virtual link information of all OSPFv3
processes is displayed.
information. If no process is specified, virtual link information of all OSPFv3
processes is displayed.
Examples
# Display OSPFv3 virtual link information.
<Sysname> display ospfv3 vlink
Virtual Link VLINK1 to router 1.1.1.1 is up
Transit area :0.0.0.1 via interface Serial2/0, instance ID: 0
Local address: 2000:1::1
Remote address: 2001:1:1::1
Transmit Delay is 1 sec, State: P-To-P,
Timer intervals configured, Hello: 10, Dead: 40, Wait: 40, Re
transmit: 5
Table 314 Description on the fields of the display ospfv3 topology command
Field Description
Type
Type of node
ID(If-Index) Router
ID
Bits Flag
bit
Metric Cost
value
Next-Hop Next
hop
Interface Outbound
interface