3com MSR 20-20 참조 매뉴얼
133
display dsl status
Syntax
display dsl status interface atm interface-number
View
Any view
Parameter
interface-number: Specifies a G.SHDSL interface to view the status information
about.
about.
Description
Use the display dsl status command to display status information about the
specified G.SHDSL interface.
specified G.SHDSL interface.
Example
# Display status information about ATM 5/0, which is a two-wire G.SHDSL
interface that is up.
interface that is up.
<Sysname> display dsl status interface atm 5/0
Operating Mode: CPE
DSL Mode:
SHDSL Annex B
Configured Wire Type:
2
Line A Statistics since last activation:
CRC:
0
LOSW Defect:
0
ES:
0
SES:
0
UAS:
0
TX EOC:
0
RX EOC:
0
Line A status:
Xcvr Op State:
Data Mode
Last Fail Op State:
0x00
Frame Sync:
in sync
Line Rate(Kbps):
2312
Wire Type:
2
SNR Margin(dB): 16.30
Loop Attenuation(dB):
0.00
RecvGain(dB):
6.07
TxPower(dBm):
9.50
Power Backoff:
enable
Power Backoff Level:
5
Tip/Ring Reversal:
Reversed
FrmOH Stat:
0x00
Rmt Encoder A : 0x0000016e
Target Margin
Target margin
Line Rate
Line rate
PSD Mode
Power spectral density mode: symmetric or asymmetric
Power-Backoff Power
compensation
LinkCheck
State of link check: enable or disable
Actual Handshake Status
--
Local Handshake Status
--
Remote Handshake Status
--
Table 1 Description on the fields of the display dsl configuration command
Field Description