3com MSR 20-20 참조 매뉴얼
1450
C
HAPTER
92: MLD C
ONFIGURATION
C
OMMANDS
View
Interface view
Parameter
acl6-number: Number of a basic or advanced IPv6 ACL, in the range of 2000 to
3999.
3999.
version-number: MLD version number, 1 or 2. If you do not specify an MLD
version, the configured group filter will apply to MLD reports of both version 1 and
version 2.
version, the configured group filter will apply to MLD reports of both version 1 and
version 2.
Description
Use the mld group-policy command to configure an IPv6 multicast group filter
on the current interface to limit access to the IPv6 multicast group.
on the current interface to limit access to the IPv6 multicast group.
Use the undo mld group-policy command to remove the configured IPv6
multicast group filter.
multicast group filter.
By default, no IPv6 multicast group filter is configured by default, that is, a host
can join any IPv6 multicast group.
can join any IPv6 multicast group.
n
When you use an advanced IPv6 ACL as a filter, the source address in the IPv6 ACL
is the multicast source address specified in the MLDv2 report message, instead of
the source address in the IPv6 message.
is the multicast source address specified in the MLDv2 report message, instead of
the source address in the IPv6 message.
Example
# Configure an IPv6 ACL so that hosts on the subnet attached to Ethernet 1/0 can
join the IPv6 multicast group FF03::101 only.
join the IPv6 multicast group FF03::101 only.
<Sysname> system-view
[Sysname] acl ipv6 number 2005
[Sysname-acl6-basic-2005] rule permit source ff03::101 16
[Sysname-acl6-basic-2005] quit
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] mld group-policy 2005
mld last-listener-query-interval
Syntax
mld last-listener-query-interval interval
undo mld last-listener-query-interval
View
Interface view
Parameter
interval: Last listener query interval in seconds, in the range of 1 to 5.
Description
Use the mld last-listener-query-interval command to configure the last
listener query interval on the current interface.
listener query interval on the current interface.
Use the undo mld last-listener-query-interval command to restore the
default configuration.
default configuration.
By default, the last listener query interval is 1 second.
Related command: