3com MSR 20-20 참조 매뉴얼

C

HAPTER

 92: MLD C

ONFIGURATION

 C

OMMANDS

# Set the MLD version to MLDv2 on Ethernet 1/0.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] mld version 2 

MLD view

None

Use the require-router-alert command to globally configure the device to 
discard MLD messages without the Router-Alert option.

Use the undo require-router-alert command to restore the default 
configuration.

By default, the device does not check the Router-Alert option, that is, it forwards 
all received MLD messages to the upper layer protocol for processing.

mld require-router-alert and send-router-alert (MLD view).

# Globally configure the device to discard MLD messages without the Router-Alert 
option.

<Sysname> system-view

[Sysname] mld

[Sysname-mld] require-router-alert 

reset mld group { all | interface interface-type interface-number { all | 
ipv6-group-address [ prefix-length ] [ ipv6-source-address [ prefix-length ] ] } }

User view

all: Clears all MLD forwarding entries.

interface interface-type interface-number: Clears the MLD forwarding entries on 
the specified interface.

ipv6-group-address: IPv6 address of the specified multicast group, in the range of 
FFxy::/16, where x and y represent any hexadecimal number ranging from 0 to F.

ipv6-source-address: IPv6 address of the specified multicast source.