3com MSR 20-20 참조 매뉴얼

ipv6-source-address: Displays the information of the IPv6 unicast route to a 
particular IPv6 multicast source. If you do not provide this argument, this 
command will display the information about all IPv6 unicast routes used by IPv6 
PIM.

Use the display pim ipv6 claimed-route command to view the information of 
IPv6 unicast routes used by IPv6 PIM.

If an (S, G) is marked SPT, this (S, G) entry uses an IPv6 unicast route.

# View the information of all IPv6 unicast routes used by IPv6 PIM.

<Sysname> display pim ipv6 claimed-route

RPF information about: 2001::2

RPF interface: Ethernet1/0, RPF neighbor: FE80::A01:100:1

Referenced prefix/prefix length: 2001::/64

Referenced route type: igp

RPF-route selecting rule: preference-preferred

The (S, G) or (*, G) list dependent on this route entry

(2001::2, FF03::101) 

display pim ipv6 control-message counters [ message-type { probe | register | 
register-stop } | [ interface interface-type interface-number | message-type { assert | 
bsr | crp | graft | graft-ack | hello | join-prune | state-refresh } ]  * ]

Any view

probe: Displays the number of null register messages.

register: Displays the number of register messages.

register-stop: Displays the number of register-stop messages.

interface interface-type interface-number: Displays the number of IPv6 PIM 
control messages on the specified interface.

assert: Displays the number of assert messages.

bsr: Displays the number of bootstrap messages.

Table 355   Description on the fields of the display pim ipv6 claimed-route command

RPF interface: 

RPF interface type and number 

RPF neighbor: 

IP address of the RPF neighbor 

Referenced prefix/prefix length: 

Address/mask of the reference route 

Referenced route type: 

Type of the referenced route 

RPF-route selecting rule: 

Rule of RPF route selection 

The (S,G) or (*,G) list dependent on this route 
entry 

(S,G) or (*, G) entries using this route