3com MSR 20-20 참조 매뉴얼
1495
register-whole-checksum (IPv6 PIM view)
Syntax
register-whole-checksum
undo register-whole-checksum
View
IPv6 PIM view
Parameter
None
Description
Use the register-whole-checksum command to configure the router to
calculate the checksum based on the entire register message.
calculate the checksum based on the entire register message.
Use the undo register-whole-checksum command to restore the default
configuration.
configuration.
By default, the checksum is calculated based only on the header in the register
message.
message.
Related command:
Example
# Configure the router to calculate the checksum based on the entire register
message.
message.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] register-whole-checksum
reset pim ipv6 control-message counters
Syntax
reset pim ipv6 control-message counters [ interface interface-type
interface-number ]
interface-number ]
View
User view
Parameter
interface-type interface-number: Specifies to reset the IPv6 PIM control message
counter on a particular interface. If no interface is specified, this command will
clear the statistics information about IPv6 PIM control messages on all interfaces.
counter on a particular interface. If no interface is specified, this command will
clear the statistics information about IPv6 PIM control messages on all interfaces.
Description
Use the reset pim ipv6 control-message counters command to reset IPv6
PIM control message counters.
PIM control message counters.
Example
# Reset IPv6 PIM control message counters on all interfaces.
<Sysname> reset pim ipv6 control-message counters