3com MSR 20-20 참조 매뉴얼

C

HAPTER

 98: MPLS L3VPN C

ONFIGURATION

 C

OMMANDS

■

A tag configured with the route-tag command has the second highest priority.

■

A tag configured with the default tag command has the lowest priority.

A received Type 5 or Type 7 LSA is neglected in route calculation if its tag is the 
same as the local one.

n

# Configure the route tag for OSPF process 100 as 100.

<Sysname> system-view

[Sysname] ospf 100

[Sysname-ospf-100] route-tag 100 

routing-table limit number { warn-threshold | simply-alert }

VPN instance view

number: Maximum number of routes for the VPN instance to support, in the 
range 1 to 1024 for MSR20 and MSR30 series routers and 1 to 2048 for MSR50 
series routers.

warn-threshold: Threshold for rejecting new routes. It is expressed in the 
percentage of the specified maximum number of routes for the VPN instance. It 
ranges from 1 to 100.

simply-alert: Specifies that when the maximum number of routes exceeds the 
threshold, the system still accepts routes and generates only a SYSLOG error 
message.

Use the routing-table limit command to limit the maximum number of routes 
in a VPN instance, preventing too many routes from being accepted a PE.

Use he undo routing-table limit command to restore the default.

The default maximum number of routes that a VPN instance supports varies by 
device.

# Specify that VPN instance vpn1 can receive up to 1,000 routes, and can receive 
new routes after the threshold is exceeded.

<Sysname> system-view

[Sysname] ip vpn-instance vpn1

[Sysname-vpn-instance-vpn1] route-distinguisher 100:1

[Sysname-vpn-instance-vpn1] routing-table limit 1000 simply-alert