3com MSR 20-20 참조 매뉴얼
1726
C
HAPTER
99: VAM S
ERVER
C
ONFIGURATION
C
OMMANDS
public-ip-address: Public IP address of Hub.
Description
Use the hub private-ip command to specify the IP address of Hub.
Use the undo hub private-ip command to remove the IP address of the
specified Hub.
specified Hub.
By default, no Hub IP address is configured.
Note that:
■
You can specify only the private IP address of Hub. When Hub is added to a
VPN domain, the VAM server can obtain the mapping information between the
registered public and private addresses of the Hub.
VPN domain, the VAM server can obtain the mapping information between the
registered public and private addresses of the Hub.
■
Currently, up to two Hub addresses can be configured on the VAM server.
Related command:
Example
# Specifies in VPN 1 the public and private IP addresses of Hub as 123.0.0.1 and
10.1.1.1 respectively.
10.1.1.1 respectively.
<Sysname> system-view
[Sysname] vam server vpn 1
[Sysname-vam-server-vpn-1] hub private-ip 10.1.1.1 public-ip 123.0.0.1
keepalive interval
Syntax
keepalive interval time-interval
undo keepalive interval
View
VPN domain view
Parameter
time-interval: Interval for sending keepalive message from VAM client. It is in the
range 5 to 60 seconds.
range 5 to 60 seconds.
Description
Use the keepalive interval command to configure the interval for sending
keepalive messages from VAM client to VAM server.
keepalive messages from VAM client to VAM server.
Use the undo keepalive interval command to restore to the default value.
By default, the interval for sending keepalive message from VAM client is 10
seconds.
seconds.
Note that the VAM server sends this setting in a registration response to its clients.
All clients in a VPN have the same keepalive settings, but if you change the
keepalive settings of the server, the new settings are sent to only clients that
register later; all clients registering before use the old settings.
All clients in a VPN have the same keepalive settings, but if you change the
keepalive settings of the server, the new settings are sent to only clients that
register later; all clients registering before use the old settings.
Related command: