3com MSR 20-20 참조 매뉴얼
1752
C
HAPTER
103: GRE C
ONFIGURATION
C
OMMANDS
encapsulation-limit
Syntax
encapsulation-limit [ number ]
undo encapsulation-limit
View
Tunnel interface view
Parameter
number: Number of encapsulations in a tunnel, in the range 1 to 10.
Description
Use the encapsulation-limit command to configure the maximum number of
encapsulations on a tunnel.
encapsulations on a tunnel.
Use the undo encapsulation-limit command to remove the configuration.
By default, the maximum encapsulation limit is 4.
The encapsulation limit applies to only IPv6 over IPv6 tunnels.
Example
# Configure the encapsulation limit on a tunnel to 3.
<Sysname1> system-view
[Sysname1] interface tunnel 2
[Sysname-tunnel2] encapsulation-limit 3
gre checksum
Syntax
gre checksum
undo gre checksum
View
Tunnel interface view
Table 469 Description on the fields of the display ipv6 interface tunnel command
Field Description
Tunnel0 current state
Status of the physical layer of the tunnel interface, UP or
DOWN
DOWN
Line protocol current state
Status of the link layer of the tunnel interface, UP or DOWN
IPv6
Whether IPv6 is enabled on the tunnel interface
link-local address
Link-local address of the tunnel interface
Global unicast address(es)
Global unicast addresses of the tunnel interface
Joined group address(es)
Multicast addresses of the tunnel interface
MTU
Maximum transmission unit of the tunnel
ND reachable time
Interval during which the neighbor is considered reachable
ND retransmit interval
Neighbor discovery packet retransmission interval
Hosts use stateless autoconfig
for addresses
for addresses
Hosts use the stateless auto-configuration mode to acquire
an IPv6 addresses.
an IPv6 addresses.