3com MSR 20-20 참조 매뉴얼

C

HAPTER

 104: L2TP C

ONFIGURATION

 C

OMMANDS

display l2tp tunnel.

# Disconnect all tunnels with the remote name of AS8010.

<Sysname> reset l2tp tunnel AS8010 

start l2tp ip ip-address&<1-5> { domain domain-name | fullusername user-name }

L2TP group view

ip-address&<1-5>: IP addresses of the tunnel peers (LNSs). &<1-5> means that 
you can specify up to five IP addresses.

domain-name: Name of the domain initiating a connection request, a case 
sensivive string of 1 to 30 characters.

user-name: Full qualified name of the user initiating a connection request, a case 
sensitive string of 1 to 32 characters.

Use the start l2tp command to enable the device to initiate tunneling requests to 
one or more IP addresses for one or more specified VPN users.

Use the undo start to remove the specified triggering condition.

Note that:

■

The start l2tp command is available for only LACs.

■

An LAC can initiate tunneling requests for users in a specified domain. For 
example, if the domain name of a company is aabbcc.net, users with such a 
domain name are considered VPN users.

■

You can specify a single VPN user by giving the fully qualified name of the user.

■

When an LAC detects a VPN user, it initiates an L2TP tunneling request to LNSs 
one by one in their configuration order until it receives the acknowledgement 
of an LNS, which is considered the tunnel peer.

# Initiate L2TP tunneling requests to LNS 202.38.168.1 for users in domain 
aabbcc.net.

<Sysname> system-view

[Sysname] l2tp-group 1

[Sysname-l2tp1] start l2tp ip 202.38.168.1 domain aabbcc.net