3com MSR 20-20 참조 매뉴얼
1885
ebs
Syntax
ebs [ inbound | outbound ] excess-burst-size
undo ebs [ inbound | outbound ]
View
Frame relay class view
Parameters
inbound: Sets the EBS in inbound direction, valid only when FRTP is enabled on
the interface.
the interface.
outbound: Sets EBS in outbound direction, valid only when FRTS is enabled on
the interface.
the interface.
excess-burst-size: EBS in bit, ranging from 0 to 16000000. It defaults to 0 bit.
Description
Use the ebs command to set EBS of FR virtual circuit.
Use the undo ebs command to restore the default value.
EBS is the maximum of the part that packet traffic exceeds the committed burst
size (CBS) within an interval of Tc. When congestion occurs on the network, this
part of excess traffic will be first discarded.
size (CBS) within an interval of Tc. When congestion occurs on the network, this
part of excess traffic will be first discarded.
When this command is used, the set EBS value will be valid in both inbound and
outbound directions if the parameters inbound and outbound are not specified.
outbound directions if the parameters inbound and outbound are not specified.
Related commands:
Examples
# Set the EBS of the FR class named test1 to 32000 bits.
<Sysname> system-view
[Sysname] fr class test1
[Sysname-fr-class-test1] ebs 32000
fifo queue-length
Syntax
fifo queue-length queue-length
undo fifo queue-length
View
Frame relay class view
Parameters
queue-length: FIFO queue length, namely, the maximum number of packets that
can be held by the queue, ranging from 1 to 1024. By default, it is 40.
can be held by the queue, ranging from 1 to 1024. By default, it is 40.
Description
Use the fifo queue-length command to set the FIFO queue length of FR virtual
circuit.
circuit.
Use the undo fifo queue-length command to restore the default value.