3com MSR 20-20 참조 매뉴얼
2074
C
HAPTER
135: P
ORTAL
C
ONFIGURATION
C
OMMANDS
000d-88f8-0eab
2.2.2.2
0
Ethernet1/0
Total 1 user(s) matched, 1 listed.
portal auth-network
Syntax
portal auth-network network-address { mask-length | mask }
undo portal auth-network { network-address | all }
View
Interface view
Parameter
network-address: Authentication subnet address.
mask-length: Length of the subnet mask, in the range of 0 to 32.
mask: Subnet mask, in dotted decimal notation.
all: Specifies all authentication subnets.
Description
Use the portal auth-network command to configure a portal authentication
subnet.
subnet.
Use the undo portal auth-network command to remove the configuration.
Note that this command is applicable to only Layer 3 authentication. The portal
authentication subnet for direct authentication is any source IP address, and the
portal authentication subnet for re-DHCP authentication is the one determined by
the private IP address of the interface.
authentication subnet for direct authentication is any source IP address, and the
portal authentication subnet for re-DHCP authentication is the one determined by
the private IP address of the interface.
By default, the portal authentication subnet is 0.0.0.0/0, meaning to authenticate
users in all subnets.
users in all subnets.
Example
# Set the portal authentication subnet to 10.10.10.0/24.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] portal auth-network 10.10.10.0 24
Table 543 Description on the fields of the display portal user command
Field Description
Index
Index of a portal user
State
Current state of a portal user
SubState
Current sub-state of a portal user
MAC
MAC address of a portal user
IP
IP address of a portal user
Vlan
VLAN where a portal user is
Interface
Interface to which a portal user is attached
Total 1 user(s) matched, 1 listed
Counts of portal users