3com MSR 20-20 참조 매뉴얼

Note that:

■

This command applies to only manual IPSec policies.

■

When configuring an IPSec policy, you need to set the parameters of both the 
inbound and outbound SAs.

■

The encryption key for the inbound SA at the local end must be the same as 
that for the outbound SA at the remote end, and the encryption key for the 
outbound SA at the local end must be the same as that for the inbound SA at 
the remote end.

ipsec policy (system view).

# Configure the encryption key for the inbound and outbound SAs using ESP as 
0x1234567890abcdef and 0xabcdefabcdef1234 respectively.

<Sysname> system-view

[Sysname] ipsec policy policy1 100 manual

[Sysname-ipsec-policy-manual-policy1-100] sa encryption-hex inbound

esp 1234567890abcdef

[Sysname-ipsec-policy-manual-policy1-100] sa encryption-hex outbound

esp abcdefabcdef1234 

sa spi { inbound | outbound } { ah | esp } spi-number

undo sa spi { inbound | outbound } { ah | esp }

IPSec policy view

inbound: Specifies the inbound SA through which IPSec processes the received 
packets.

outbound: Specifies the outbound SA through which IPSec processes the packets 
to be sent.

ah: Uses AH.

esp: Uses ESP.

spi-number: Security parameters index (SPI) in the SA triplet, in the range 256 to 
4294967295.

Use the sa spi command to set the SPI for SA.

Use the undo sa spi command to remove the configuration.

Note that:

■

This command applies to only manual IPSec policies.