3com MSR 20-20 참조 매뉴얼
2169
Description
Use the peer command to set the subnet type of the peer gateway for IKE
negotiation.
negotiation.
Use the undo peer command to restore the default.
By default, the subnet is a single one. You can use this command to enable
interoperability with a Netscreen device.
interoperability with a Netscreen device.
Example
# Set the subnet type of the peer gateway to multiple.
<Sysname> system-view
[Sysname] ike peer xhy
[Sysname-ike-peer-xhy] peer multi-subnet
pre-shared-key
Syntax
pre-shared-key key
undo pre-shared-key
View
IKE peer view
Parameter
key: Pre-shared key, a case sensitive string of 1 to 128 characters.
Description
Use the pre-shared-key command to configure the pre-shared key to be used in
IKE negotiation.
IKE negotiation.
Use the undo pre-shared-key command to remove the configuration.
Related command:
Example
# Set the pre-shared key used in IKE negotiation to abcde.
<Sysname> system-view
[Sysname] ike peer peer1
[Sysname-ike-peer-peer1] pre-shared-key abcde
remote-address
Syntax
remote-address low-ip-address [ high-ip-address ]
undo remote-address
View
IKE peer view
Parameter
low-ip-address: Remote IP address of the IPSec tunnel. It is the lowest address in
the address range if you want to specify a range of addresses.
the address range if you want to specify a range of addresses.
high-ip-address: Highest address in the address range if you want to specify a
ragne of addresses.
ragne of addresses.