3com MSR 20-20 참조 매뉴얼

standby bandwidth size

Interface view

size: Specifies the main interface bandwidth used for setting the thresholds, in the 
range 0 to 4000000 kbps.

UPDELAY 

The backup interface is experiencing a delay before it transits from the 
non-working state to the working state to take over. 

DOWN 

The backup interface cannot work normally. 

DOWNDELAY 

The backup interface is experiencing a delay before it transits from the 
working state to the non-working state. At this time, the backup interface 
is probably still working. 

STANDBY 

State of the backup interface when the main interface is working. At this 
time, the backup interface cannot send or receive data.

Table 586   Backup flags

M---MAIN Indicates 

that 

the 

interface is a main one. 

B---BACKUP 

Indicates that the interface is a backup one. 

V---MOVED 

Indicates that the interface or the main interface of the interface, or all 
backup interfaces of the interface are all removed. 

U---USED 

Indicates that the interface is being used as a main interface or backup 
interface. 

D---LOAD 

Indicates that the main interface participates in load sharing. 

P---PULLED 

Indicates that the interface board where the interface is located is 
removed.

Table 587   Load sharing states

WAKE 

The backup interface is working in the load sharing state to transmit 
data together with the main interface. 

TO-HYPNOTIZE 

The backup interface is transiting from the working state to the 
non-working state after the traffic size decreases below the lower 
backup load sharing threshold. In this state, the backup interface is still 
working. 

TO-WAKE 

The backup interface is transiting from the non-working state to the 
working state after the traffic size increases above the upper backup 
load sharing threshold. 

Null 

State other than the above three. At this time, the value for the 
loadstate field is null.

Table 585   Backup states of the backup interface