3com MSR 20-20 참조 매뉴얼

C

HAPTER

 147: VRRP C

ONFIGURATION

 C

OMMANDS

 

FOR

 IP

V

6

vrrp ipv6 vrid virtual-router-id authentication-mode simple key

undo vrrp ipv6 vrid virtual-router-id authentication-mode

Interface view

virtual-router-id: VRRP standby group number, in the range 1 to 255.

simple: Sets the authentication mode to plain text authentication.

key: Authentication key of 1 to 8 case-sensitive characters in plain text.

Use the vrrp ipv6 vrid virtual-router-id authentication-mode simple key 
command to configure authentication mode and authentication key for the VRRP 
standby groups to send and receive VRRP packets.

Use the undo vrrp ipv6 vrid virtual-router-id authentication-mode command 
to restore the default.

By default, authentication is disabled.

Note that:

■

Before executing the command, create a standby group on an interface and 
configure the virtual IP address of the standby group.

■

You may configure different authentication types and authentication keys for 
the standby groups on an interface. However, the members of the same 
standby group must use the same authentication mode and authentication key.

# Set the authentication mode and authentication key for VRRP standby group 10 
on interface Ethernet 1/0 to send and receive VRRP packets.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] vrrp ipv6 vrid 10 virtual-ip fe80::2 link-local

[Sysname-Ethernet1/0] vrrp ipv6 vrid 10 authentication-mode simple Sysname 

vrrp ipv6 vrid virtual-router-id preempt-mode [ timer delay delay-value ]

undo vrrp ipv6 vrid virtual-router-id preempt-mode [ timer delay ]

Interface view

virtual-router-id: Virtual router ID or VRRP standby group number, in the range 1 
to 255.