3com MSR 20-20 참조 매뉴얼
2284
C
HAPTER
149: NQA C
LIENT
C
ONFIGURATION
C
OMMANDS
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source interface ethernet 1/0
source ip
Syntax
source ip ip-address
undo source ip
View
DLSw/FTP/HTTP/ICMP-echo/SNMP/TCP/UDP-echo/UDP-jitter test type view
Parameter
ip-address: Source IP address of a test operation.
Description
Use the source ip command to configure the source IP address of ICMP probe
requests in a test operation.
requests in a test operation.
Use the undo source ip command to remove the configured source address.
That is, the IP address of the interface sending a probe request serves as the source
IP address of the probe request.
That is, the IP address of the interface sending a probe request serves as the source
IP address of the probe request.
By default, no source IP address is specified. For an ICMP-echo test, if no source IP
address is specified, but the source interface is specified, the IP address of the
source interface is taken as the source IP address of ICMP probe requests.
address is specified, but the source interface is specified, the IP address of the
source interface is taken as the source IP address of ICMP probe requests.
Related command:
Example
# Configure the source IP address of an ICMP-echo probe request as 10.1.1.1.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source ip 10.1.1.1
source port
Syntax
source port port-number
undo source port
View
SNMP/UDP-echo/UDP-jitter test type view
Parameter
port-number: Source port number for a test operation, in the range 1 to 50000.
Description
Use the source port command to configure the source port of ICMP probe
requests in a test operation.
requests in a test operation.
Use the undo source port command to remove the configured port number.