3com MSR 20-20 참조 매뉴얼

Note that:

■

You need to configure the command on the NQA server for TCP tests only.

■

The IP address and port number must be consistent with those on the NQA 
client and must be different from those for an existing listening service.

■

The IP address must be that of an interface on the NQA server. Otherwise, the 
configuration will be invalid.

# Create a TCP listening service by using the IP address 169.254.10.2 and port 
9000.

<Sysname> system-view

[Sysname] nqa server tcp-connect 169.254.10.2 9000 

nqa server udp-echo ip-address port-number

undo nqa server udp-echo ip-address port-number

System view

ip-address: IP address specified for the UDP listening service on the NQA server.

port-number: Port number specified for the UDP listening service on the NQA 
server, in the range 1 to 50000.

Use the nqa-server udpecho command to create a UDP listening service on the 
NQA server.

Use the undo nqa-server udpecho command to remove the UDP listening 
service created.

Note that:

■

You need to configure the command on the NQA server for UDP-jitter and 
UDP-echo tests only.

■

The IP address and port number must be consistent with those configured on 
the NQA client and must be different from those of an existing listening 
service.

■

The IP address must be that of an interface on the NQA server. Otherwise, the 
configuration will be invalid.

# Create a UDP listening service by using the IP address 169.254.10.2 and port 
9000.