3com MSR 20-20 참조 매뉴얼
2588
C
HAPTER
173: V
O
IP C
ONFIGURATION
C
OMMANDS
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dtmf amplitude -8.0
dtmf sensitivity-level
Syntax
dtmf sensitivity-level { high | low }
undo dtmf sensitivity-level
View
Analog FXS/FXO voice subscriber line view
Parameter
high: Sets the DTMF detection sensitivity high. In this mode, the reliability is low
and detection errors may occur.
and detection errors may occur.
low: Sets the DTMF detection sensitivity low. In this mode, the reliability is high,
but DTMF undetection may occur.
but DTMF undetection may occur.
Description
Use the dtmf sensitivity-level command to set the DTMF detection sensitivity
level.
level.
Use the undo dtmf sensitivity-level command to restore the default detection
sensitivity level.
sensitivity level.
By default, the DTMF detection sensitivity level is high.
This command is valid only for FXS/FXO interfaces.
Example
# Set the DTMF detection sensitivity level of voice subscriber line 1/0 to low.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] dtmf sensitivity-level low
dtmf time
Syntax
dtmf time { interval | persist } milliseconds
undo dtmf time { interval | persist }
View
Voice view
Parameter
persist: Specifies the persisting time of sending DTMF.
Interval: Specifies the interval for sending DTMF.
milliseconds: Time in milliseconds, in the range of 50 to 500.
Description
Use the dtmf time command to configure the related time parameters of DTMF.