3com MSR 20-20 참조 매뉴얼

C

HAPTER

 173: V

O

IP C

ONFIGURATION

 C

OMMANDS

E&M voice subscriber line view

delay: When using the delay start mode, the calling end occupies the trunk line, 
and the called end, such as PBX, will also enter the hook-off state to respond the 
caller till it is ready for receiving the called number.

immediate: Immediate start mode. The caller end hooks off to seize the line 
through line E and sends the called number. The prerequisite for using the 
immediate start mode is: The equipment at the remote end should listen to the 
dial signal immediately after identifying the off-hook signal.

wink: Wink start mode. The caller end hooks off to seize the line through line E, 
and it has to wait for a wink signal from the remote end before sending out the 
called number.

Use the em-signal command to configure a start mode for an analog E&M voice 
subscriber line.

Use the undo em-signal command to restore the default start mode.

By default, the immediate start mode is selected for the analog E&M subscriber 
line.

delay.

# Configure delay mode.

<Sysname> system-view

[Sysname] voice-setup

[Sysname-voice] subscriber-line 1/0

[Sysname-voice-line1/0] em-signal delay 

entity entity-number { pots | voip }

undo entity { entity-number | all | pots | voip }

Voice dial program view

entity-number: Identifies a voice entity. The value ranges from 1 to 2147483647.

all: All voice entities.

pots: Indicates that the voice entity originates a call from the local voice subscriber 
line.

voip: Indicates that the voice entity originates a call from the network side.

Use the entity command to enter voice entity view, or configure a voice entity 
and then enter its view if the voice entity does not exist.