3com MSR 20-20 참조 매뉴얼
2668
C
HAPTER
175: E1
AND
T1 C
ONFIGURATION
C
OMMANDS
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 5 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 5
[Sysname-cas1/0:5] sendring ringbusy enable
signal-value
Syntax
signal-value { received idle | received seize | transmit idle | transmit seize } ABCD
undo signal-value { received idle | received seize | transmit idle | transmit seize }
View
Digital E&M voice subscriber line view
Parameter
received idle: Indicates the receive idle signal of digital E&M signaling.
received seize: Indicates the receive seized signal of digital E&M signaling.
transmit idle: Indicates the transmit idle signal of digital E&M signaling.
transmit seize: Indicates the transmit seized signal of digital E&M signaling.
ABCD: Default ABCD bit pattern during transmission, with each bit taking the
value of 0 or 1.
value of 0 or 1.
Description
Use the signal-value command to configure the ABCD bit patterns of idle
receive, receive seized, idle transmit, and transmit seized signals on the digital
E&M voice subscriber line.
receive, receive seized, idle transmit, and transmit seized signals on the digital
E&M voice subscriber line.
Use the undo signal-value command to restore the defaults.
By default, the ABCD bit patterns of the receive idle signal and the transmit idle
signal are 1101, and the ABCD bit patterns of the receive seized signal and the
transmit seized signal are 0101. After changing the ABCD bit pattern of a digital
E&M signal, you must shut down the digital E&M subscriber line with the
shutdown command and then bring the line up with the undo shutdown
command. Otherwise, the voice subscriber line cannot work normally.
signal are 1101, and the ABCD bit patterns of the receive seized signal and the
transmit seized signal are 0101. After changing the ABCD bit pattern of a digital
E&M signal, you must shut down the digital E&M subscriber line with the
shutdown command and then bring the line up with the undo shutdown
command. Otherwise, the voice subscriber line cannot work normally.
Related command:
Example
# Set the ABCD bit pattern to 1011 for the transmit seized signal on digital E&M
subscriber line 1/0:0.
subscriber line 1/0:0.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscirber-line1/0:0
[Sysname-voice-line1/0:0] signal-value transmit seize 1011
special-character
Syntax
special-character character number