3com MSR 20-20 참조 매뉴얼

C

HAPTER

 20: DCC C

ONFIGURATION

 C

OMMANDS

priority priority: Priority of a physical interface in the dialer bundle. The priority 
argument is in the range 1 to 255. The higher the number, the higher the priority. 
The physical interface with higher priority is used first. The default priority is 1.

Use the dialer bundle-member command to assign a physical interface to a 
dialer bundle in RS-DCC.

Use the undo dialer bundle-member command to remove a physical interface 
from a dialer bundle.

By default, a dialer bundle contains no physical interface.

This command applies only to physical interfaces. A physical interface can belong 
to multiple dialer bundles.

# Assign interface BRI 1/0 to Dialer bundle 1 and Dialer bundle 2, with a priority of 
50 in both.

<Sysname> system-view

[Sysname] interface bri 1/0

[Sysname-Bri1/0] dialer bundle-member 1 priority 50

[Sysname-Bri1/0] dialer bundle-member 2 priority 50 

dialer callback-center [ user | dial-number ] *

Dial interface (physical or dialer) view

user: Sets the callback reference to user mode where DCC identifies which dial 
string is to be used for placing a return call by looking at the remote username 
configured in the dialer route command.

dial-number: Sets the callback reference to dial number mode, where DCC uses 
dial strings configured in service-type ppp callback-number commands in local 
user view to place return calls. When placing a return call, it needs to identify the 
dial string to be used by comparing the remote username obtained in PPP 
negotiation against the local user database for a match.

Use the dialer callback-center command to configure the PPP callback 
reference.

Use the undo dialer callback-center command to remove the setting.

By default, no PPP callback reference is configured.

This command is mandatory on the PPP callback server.