3com MSR 20-20 참조 매뉴얼

C

HAPTER

 20: DCC C

ONFIGURATION

 C

OMMANDS

If you perform the dialer enable-circular command or its undo form on a 
non-dial interface, do the same on the interface to recover it.

# Enable C-DCC on interface Serial 2/0.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] dialer enable-circular 

dialer flow-interval interval

System view

interval: Traffic statistics interval, in the range 1 to 1500 seconds.

Use the dialer flow-interval command to configure the traffic statistics interval 
for DCC.

Use the undo dialer flow-interval command to restore the default.

By default, the traffic statistics interval for DCC is 20 seconds.

This command is only useful for traffic-triggered dial in DCC. For example, when 
using traffic-triggered MP link bundling with DCC, you may need to configure 
DCC to send traffic statistics about dialup links at certain intervals to MP.

dialer threshold.

# Set traffic statistics interval to three seconds for DCC.

<Sysname> system-view

[Sysname] dialer flow-interval 3 

dialer isdn-leased number

undo dialer isdn-leased number

Dial interface (Physical interface) view

number: Number of the ISDN B channel for leased line connection. It ranges from 
0 to 1 for a BRI interface, and 0 to 30 (with 15 excluded for the control channel)