3com MSR 20-20 참조 매뉴얼
352
C
HAPTER
21: B
ASIC
DLS
W
C
ONFIGURATION
C
OMMANDS
Note that you need to remove all IP related configurations on the interface before
enabling SDLC, because SDLC cannot underlie the IP protocol. For example, you
need to delete the IP address of the interface.
enabling SDLC, because SDLC cannot underlie the IP protocol. For example, you
need to delete the IP address of the interface.
Example
# Configure Serial 2/0 to use SDLC as the link layer encapsulation protocol.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] link-protocol sdlc
llc2 max-ack
Syntax
llc2 max-ack length
undo llc2 max-ack
View
Ethernet interface view
Parameter
length: The maximum number of information frames the router can receive before
it must send an acknowledgment, in the range of 1 to 127.
it must send an acknowledgment, in the range of 1 to 127.
Description
Use the llc2 max-ack command to configure namely the maximum number of
information frames the device can receive before it must send an
acknowledgment to the peer router.
information frames the device can receive before it must send an
acknowledgment to the peer router.
Use the undo llc2 max-ack command to restore the default setting.
By default, the maximum number of information frames the router can receive
before it must send an acknowledgment is 3.
before it must send an acknowledgment is 3.
Example
# Set the maximum number of information frames the router can receive before it
must send an acknowledgment to 5 on Ethernet 1/0.
must send an acknowledgment to 5 on Ethernet 1/0.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] llc2 max-ack 5
llc2 max-pdu
Syntax
llc2 max-pdu length
undo llc2 max-pdu
View
Ethernet interface view
Parameter
length: Maximum LLC2 PDU size in bytes, in the range of 1 to 1,700.
Description
Use the max-pdu command to configure the maximum LLC2 PDU size.