3com MSR 20-20 참조 매뉴얼
593
undo isdn two-tei
View
BRI interface view
Parameter
None
Description
Use the isdn two-tei command to have the router requests the connected switch
for a new TEI value before calling for a B channel.
for a new TEI value before calling for a B channel.
Use the undo isdn two-tei command to restore the default TEI handling practice
on the BRI interface.
on the BRI interface.
This command applies in the situation where the switch with which the router
works is an ISDN NI compliant switch (the DMS100 for example) in North America.
In this case, you must ensure that the TEI value assigned to each B channel is
unique to ensure a successful MP channel call. Otherwise, only one B channel can
be brought up and calling for MP fails.
works is an ISDN NI compliant switch (the DMS100 for example) in North America.
In this case, you must ensure that the TEI value assigned to each B channel is
unique to ensure a successful MP channel call. Otherwise, only one B channel can
be brought up and calling for MP fails.
By default, all the B channels on the BRI interface use one TEI value.
Example
# Configure the router to request the connected switch for a new TEI value before
calling to bring up a B channel.
calling to bring up a B channel.
<Sysname> system-view
[Sysname] interface bri 1/0
[Router-Bri1/0] isdn two-tei
permanent-active
Syntax
permanent-active
undo permanent-active
View
ISDN BRI interface view
Parameter
None
Description
Use the permanent-active command to specify an ISDN BRI interface to be in
permanent active state on physical layer.
permanent active state on physical layer.
Use the undo permanent-active command to cancel the configuration.
Note that these two commands are only applicable to ISDN BRI interfaces on BSV
boards and operating on network side.
boards and operating on network side.
By default, BSV interfaces operating on the network side are not in permanent
active state on physical layer.
active state on physical layer.
Note that: