3com MSR 20-20 참조 매뉴얼
677
e1 channel-set
Syntax
e1 e1-number channel-set set-number timeslot-list range
undo e1 e1-number channel-set set-number
View
CPOS interface view
Parameter
e1-number: Number of an E1 channel on the CPOS interface, in the range 1 to 63.
set-number: Channel set number, in the range 0 to 30.
timeslot-list range: Specifies a list of timeslots assigned to the channel set. The
range argument is in the range 1 to 31. While specifying timeslots, you can specify
a single timeslot in the form of a number, or timeslots in a range in the form of
number1-number2, or multiple timeslots in the form of number1,
number2-number3.
range argument is in the range 1 to 31. While specifying timeslots, you can specify
a single timeslot in the form of a number, or timeslots in a range in the form of
number1-number2, or multiple timeslots in the form of number1,
number2-number3.
Description
Use the e1 channel-set command to bundle multiple timeslots on an E1 channel
into one channel set.
into one channel set.
Use the undo e1 channel-set command to remove the channel set (also
mentioned as a bundle throughout this document).
mentioned as a bundle throughout this document).
By default, timeslot bundling is disabled on E1 channels.
When the E1 channel is channelized, its timeslot 0 is used for synchronization and
the other 31 timeslots can be bundled to form one or multiple serial interfaces.
These serial interfaces are numbered in the form of interface number/channel
number:channel set number.
the other 31 timeslots can be bundled to form one or multiple serial interfaces.
These serial interfaces are numbered in the form of interface number/channel
number:channel set number.
To guarantee the processing capacity of the system, you can have only up to 256
virtual serial interfaces on one CPOS physical interface.
virtual serial interfaces on one CPOS physical interface.
Related command:
Example
# Bundle timeslots on E1 channel 63.
<Sysname> system-view
[Sysname] controller cpos 1/0
[Sysname-Cpos1/0] e1 63 channel-set 1 timeslot-list 1-31
# Enter the view of the serial interface formed by the timeslot bundle.
T1 framer(2-1-1):
Presents how the T1 channel is multiplexed. 2-1-1
represents in order VC-3 number, TUG-2 number, and
TUG-11 number for the T1 channel.
represents in order VC-3 number, TUG-2 number, and
TUG-11 number for the T1 channel.
For its calculation principle, refer to the accompanied
operation manual.
operation manual.
Table 123 Description on the fields of the display controller cpos t1 command
Field Description