3com MSR 20-20 참조 매뉴얼

C

HAPTER

 66: NAT-PT C

ONFIGURATION

 C

OMMANDS

protocol-type: Protocol type, including TCP and UDP.

ipv4-address-destination: Destination IPv4 address to be mapped.

ipv4-port-number: IPv4 port number, in the range of 1 to 12287.

ipv6-address-destination: IPv6 address to which the destination IPv4 address is 
mapped

ipv6-port-number: IPv6 port number, in the range of 1 to 12287.

Use the natpt v4bound static command to configure the static source 
IPv4-to-IPv6 address mapping or the static destination IPv4-to-IPv6 address/port 
mapping.

Use the undo natpt v4bound static command to remove the static source 
IPv4-to-IPv6 address mapping or the static destination IPv4-to-IPv6 address/port 
mapping.

The ipv6-address prefix can be different from the NAT-PT prefix, but it is 
recommended to be the same as the NAT-PT prefix.

# Configure the static mapping from the source IPv4 address 2.3.4.9 to the 
destination IPv6 address 2001::1.

<Sysname> system-view

[Sysname] natpt v4bound static 2.3.4.9 2001::1 

natpt v6bound dynamic { acl6 number acl6-number | prefix natpt-prefix } 
{ address-group address-group [ no-pat ] | interface interface-type 
interface-number }

undo natpt v6bound dynamic { acl6 number acl6-number | prefix natpt-prefix }

System view

acl-number: IPv6 access control list (ACL) number, in the range of 2000 to 2999.

natpt-prefix: NAT-PT prefix, 96 bits in length.

address-group: IPv4 address pool number, in the range of 1 to 31.

interface-type: IPv4 interface type.

interface-number: IPv4 interface number.

no-pat: Specifies no port address translation. If the no-pat keyword is not 
provided, port address translation will be performed.