3com MSR 20-20 참조 매뉴얼
69
IP
V
6 U
NICAST
P
OLICY
R
OUTING
C
ONFIGURATION
C
OMMANDS
apply default output-interface
Syntax
apply default output-interface interface-type interface-number
undo apply default output-interface [ interface-type interface-number ]
View
IPv6 policy-based-route view
Parameter
interface-type interface-number: Specifies an interface.
Description
Use the apply default output-interface command to set a default outgoing
interface for IPv6 packets.
interface for IPv6 packets.
Use the undo apply default output-interface command to remove the
default outgoing interface.
default outgoing interface.
This command only applies to packets not finding a match in the routing table.
You can specify up to five default outgoing interfaces, implementing load
balancing based on data streams.
You can specify up to five default outgoing interfaces, implementing load
balancing based on data streams.
Related command:
apply ipv6-precedence, apply ipv6-address next-hop, apply
output-interface, apply ipv6-address default next-hop.
output-interface, apply ipv6-address default next-hop.
Example
# Set the default outgoing interface to the interface Serial 2/0.
<Sysname> system-view
[Sysname] ipv6 policy-based-route aa permit node 11
[Sysname-pbr6-aa-11] apply default output-interface serial 2/0
apply destination-based-forwarding
Syntax
apply destination-based-forwarding
undo apply destination-based-forwarding
View
IPv6 policy-based-route view
Parameter
None