3com MSR 20-20 참조 매뉴얼
920
C
HAPTER
70: T
ERMINAL
A
CCESS
C
ONFIGURATION
C
OMMANDS
By default, no hotkey is configured for connectivity test.
With the terminal connectivity test hotkey configured on the router, you can press
the hotkey to test the TCP connectivity between the terminal and the router and
that between the terminal and the FEP.
the hotkey to test the TCP connectivity between the terminal and the router and
that between the terminal and the FEP.
n
■
This command takes effect only in Telnet terminal access and TTY terminal
access.
access.
■
The ASCII value of the hotkey configured must be different from that of any
other hotkey configured on the device. Otherwise, hotkey conflicts will occur.
For example, the hotkey value cannot be set to 17 or 19 because these two
values are used for the hotkeys of flow control.
other hotkey configured on the device. Otherwise, hotkey conflicts will occur.
For example, the hotkey value cannot be set to 17 or 19 because these two
values are used for the hotkeys of flow control.
■
Using the hotkey may not get a response rapidly when the terminal displays
too much data.
too much data.
Example
# Configure the terminal connectivity test hotkey as <Alt+A>, namely, 1 96 13.
<Sysname> system-view
[Sysname] rta template abc
[Sysname-rta-template-abc] testkey 1 96 13
update changed-config
Syntax
update changed-config
View
Terminal template view
Parameters
None
Description
Use the update changed-config command to update template configurations.
If the template has been applied on the corresponding interface, the
configurations made in template view will take effect after the update
changed-config command is executed. You are recommended to complete all
terminal template configurations before applying the template on the interface.
configurations made in template view will take effect after the update
changed-config command is executed. You are recommended to complete all
terminal template configurations before applying the template on the interface.
Note that some configurations, such as source IP address configuration and
encryption, take effect only after they are updated and the connection is
reestablished.
encryption, take effect only after they are updated and the connection is
reestablished.
Example
# Set the menu hotkey under the template and update the configuration for the
hotkey to take effect.
hotkey to take effect.
<Sysname> system-view
[Sysname] rta template abc
[Sysname-rta-template-abc] menu hotkey 1
[Sysname-rta-template-abc] update changed-config