3com MSR 20-20 사용자 설명서

다운로드
페이지 240
116
C
HAPTER
 3: M
ULTIFUNCTIONAL
 I
NTERFACE
 M
ODULES
Read the mark identifying a port before you connect a cable to it, making sure 
it is the correct port. Wrong connection tends to damage interface modules 
and even the Router.
As provisioned by Bell V, cables for FXS/FXO/E&M modules do not provide 
PGND wire. For this reason, a loop should be formed via the earth ground 
between the Router and the connected switch. In practice, the PGND wire of 
the switch can be connected to the chassis of the Router;
To ensure the EMC of the whole Router, you should connect the end of the 
cable with ferrite core to the Router.
Step 1: Plug one end of the cable into the RJ-45 port on 2FXS/2FXO/2E&M;
Step 2: Connect the other end of the cable to:
Telephone set, fax or AT0 loop trunk of telephone exchange, if you have 
installed an FXS module;
Subscriber line of telephone exchange, if you have installed an FXO module;
E&M trunk of telephone exchange, if you have installed an E&M module;
MIM-HNDE Module
Introduction
High Network Data Encryption (MIM-HNDE for short) supports IPSec protocol, 
multiple hardware encryption/decryption and hash algorithm to speed up the 
encryption of the IP packets, featuring high-performance and high-reliability.
Insert MIM-HNDE module in the MIM slot of a low-end and mid-range modular 
router. The main board forwards the IP packets and implements the VPN with 
encryption feature which is complemented by encryption card.
Interface Attributes
Interface LEDs
The front panel of MIM-HNDE module is shown in the following figure:
Figure 132   MIM-HNDE panel
Table 76   MIM-HNDE module features
Feature Description 
Protocol supported 
IPSec 
Hardware algorithm 
1) key algorithm (DES, 3DES, AES)
2) Authentication algorithm 
(HMAC-MD5-96, HMAC-SHA-1-96)