3com MSR 20-20 사용자 설명서
172
C
HAPTER
4: F
LEXIBLE
I
NTERFACE
C
ARDS
Connecting the Interface
Cable
c
CAUTION: Before you connect a port, read its label carefully; a wrong connection
may impair the interface card and even damage the device.
may impair the interface card and even damage the device.
You are recommended to install a special lightning arrester at the input end of the
interface cable for better lightning protection.
interface cable for better lightning protection.
Step 1: Choose an 8E1 conversion cable appropriate to the interface type of the
device to be connected.
device to be connected.
■
If the interface impedance of the device is 75-ohm, use a 75-ohm 8E1
conversion cable.
conversion cable.
■
If the interface impedance of the device is 120-ohm, use a 120-ohm 8E1
conversion cable.
conversion cable.
Step 2: Insert the DB-68 connector of the cable to the DB-68 port on the
FIC-8E1/FIC-8E1-F card, and fasten the cable fastening screws.
FIC-8E1/FIC-8E1-F card, and fasten the cable fastening screws.
Step 3: Identify the sequence number of the other end of the 8E1/4E1 conversion
cable and connect it with a peer device.
cable and connect it with a peer device.
Step 4: Power on the router. Check the behavior of the LINK LED on the card
panel: OFF means fault has occurred on the line and signal is out of
synchronization. Check the line status.
panel: OFF means fault has occurred on the line and signal is out of
synchronization. Check the line status.
FIC-1T1/FIC-2T1/FIC-4T
1 and
FIC-1T1-F/FIC-2T1-F/FIC
-4T1-F
1 and
FIC-1T1-F/FIC-2T1-F/FIC
-4T1-F
Introduction
FIC-1T1/FIC-2T1/FIC-4T1
FIC-1T1/FIC-2T1/FIC-4T1, the 1-/2-/4-port channelized T1/PRI interface card,
transmits, receives, and processes T1 data traffic. In addition, you can use the card
for other purposes, such as CT1 access and the ISDN PRI function.
transmits, receives, and processes T1 data traffic. In addition, you can use the card
for other purposes, such as CT1 access and the ISDN PRI function.
FIC-1T1-F/FIC-2T1-F/FIC-4T1-F
FIC-1T1-F/FIC-2T1-F/FIC-4T1-F, the 1-/2-4-port fractional T1 interface card, differs
from the FIC-1T1/FIC-2T1/FIC-4T1 primarily in the sense that:
from the FIC-1T1/FIC-2T1/FIC-4T1 primarily in the sense that:
■
The FT1 operating mode supported by the T1-F cards allows only one n
× 64
kbps or n
× 56 kbps bundle to be formed on each interface, where n = 1 to 24.
However, a T1 card allows arbitrary grouping of 24 channels and multiple
bundles.
bundles.
■
The FIC-T1-F cards do not support PRI mode.
Interface Attributes
The following table describes the interface attributes of the FIC-T1/FIC-T1-F cards.