3com MSR 20-20 사용자 설명서
FIC-1POS
191
Interface LEDs
The following figure illustrates the FIC-1G.SHDSL panel:
Figure 233 FIC-1G.SHDSL panel
The following table describes the LEDs on the FIC-1G.SHDSL panel.
Interface Cable
The FIC-1G.SHDSL cards use regular telephone cables for connection.
Connecting the Interface
Cable
You simply need a telephone cable to connect the RJ11 interface on an
FIC-1G.SHDSL card to PSTN.
FIC-1G.SHDSL card to PSTN.
FIC-1POS
Introduction
FIC-1POS, the 1-port SDH/SONET interface card, supports interface rates up to
155.52 Mbps (STM-1/OC-3).
155.52 Mbps (STM-1/OC-3).
The FIC-1POS uses the protocols such as PPP, Frame Relay and HDLC at the data
link layer and IP at the network layer. It allows direct transmission of packets over
SONET/SDH. It supports:
link layer and IP at the network layer. It allows direct transmission of packets over
SONET/SDH. It supports:
■
Four types of SFP: multi-mode short-haul (1310 nm), single mode medium-haul
(1310 nm), single mode long-haul (1310 nm), and single-mode ultra-long haul
(1550 nm).
(1310 nm), single mode long-haul (1310 nm), and single-mode ultra-long haul
(1550 nm).
■
155.52 Mbps fractional interface
Interface Attributes
The following table describes the interface attributes of the FIC-1POS.
Interface rate
In single-pair mode, supports the
sending/receiving independent
symmetric rates in the range from 192
kbps to 2304 kbps in steps of 8 kbps.
sending/receiving independent
symmetric rates in the range from 192
kbps to 2304 kbps in steps of 8 kbps.
Interface cable
Telephone cable
Supported services
G.SHDSL over telephone lines
Table 135 Interface attributes of the FIC-1G.SHDSL
Attribute FIC-1G.SHDSL
Table 136 LEDs on the FIC-1G.SHDSL panel
LED Description
LINK
OFF means no link is present; ON means a
link is present.
link is present.
ACT
OFF means no data is being transmitted or
received; blinking means data is being
received or/and transmitted.
received; blinking means data is being
received or/and transmitted.