3com MSR 20-20 사용자 설명서

다운로드
페이지 240
ESM/VCPM M
ODULE
ANDE Module
Introduction
ANDE (advanced network data encryption card) supports IPSec and hardware 
expedited IP data packet encryption, thus providing encryption with high 
performance and reliability.
Installed with an ANDE card, the main board of your router can implement VPN 
with encryption provided by the ANDE card in addition to IP packet forwarding.
Interface Attributes
The following table describes the interface attributes of the FIC-HNDE.
Interface LEDs
There is no LED on the ANDE module. Display of the status of the module is 
implemented through the ESM interface LED on the main board of the router.
The following table describes the LEDs on the panel.
Installing/Removing
ANDE Card
ANDE card should be installed on the main board and the ESM slot on the MSCA 
card of MSR 20/30/50 router. The board that provides ESM slots is referred to 
hereafter as mother board. Suppose the mother board is uninstalled and put on 
the workbench.
Removing ANDE card
Follow these steps to remove the ANDE card:
Table 171   Interface attributes of the ANDE module
Attribute Description 
Protocol supported IPSec 
IPSec concurrent tunnels 
100 (implemented through software) 
Hardware algorithm 
key algorithm (DES, 3DES, AES, QC5, 
Blowfish, Cast-128 and SkipJack)
Authentication algorithm 
(HMAC-MD5-96, HMAC-SHA-1-96)
Table 172   Description of the LEDs on the panel
LED Description 
ESMx 
Green: ANDE card is in the slot and is operating normally. 
Yellow: ANDE card is in the slot but cannot be accessed by the router. 
Note:
x means the number of the slot the ESM LED is in.