Xerox 3210 사용자 가이드

다운로드
페이지 140
Maintenance_ 65
REPLACING THE PRINT CARTRIDGE
When the print cartridge is completely empty, you must replace the print 
cartridge.
The status LED and the toner-related message on the display indicates 
that the print cartridge should be replaced.
Incoming faxes are saved in memory.
At this stage, the print cartridge needs to be replaced. Check the type of 
print cartridge for your machine. (See "Ordering supplies and 
accessories" on page 83.)
1. Turn the machine off, then wait a few minutes for the machine to cool.
2. Completely open the front cover.
3. Grasp the handles on the print cartridge and pull to remove the cartridge 
from the machine.
4. Take a new print cartridge out of its package.
5. Holding both handles on the print cartridge, thoroughly rock it from side 
to side to evenly distribute the toner.
 
6. Place the print cartridge on a flat surface, as shown, and remove the 
paper covering the print cartridge by removing the tape.
7. Grasp the handles on the print cartridge. Insert the cartridge until it clicks 
into place.
8. Close the front cover. Make sure the cover is securely latched, and then 
turn the machine on.
Do not touch the green surface, the OPC drum or the front of 
each print cartridge, with your hands or any other material. Use 
the handle on each cartridge in order to avoid touching this area.
Be careful not to scratch the surface of the paper transfer belt.
If you leave the front cover open for more than a few minutes, the 
OPC drum can be exposed to light. This will cause damage to the 
OPC drum. Close the front cover should the installation need to 
be halted for any reason.
Don't use sharp objects, such as a knife or scissors, to open 
the print cartridge package. You could damage the surface of 
the print cartridge.
To prevent damage, do not expose the print cartridge to light 
for more than a few minutes. Cover it with a piece of paper to 
protect it if necessary.
If toner gets on your clothing, wipe it off with a dry cloth and wash 
it in cold water. Hot water sets toner into fabric.
If the front cover is not completely closed, the machine will not 
operate.