Gestetner f540 부록 매뉴얼

Using Network Delivery Scanner Functions

122

Received fax documents can be auto-
matically routed using ScanRouter
V2 Professional.
To route using NIC FAX, follow p.122
“Setting up ScanRouter V2 Profes-
sional” and p.122 “Fax Document De-
livery Settings”.

Preparation
You need to make Network set-
tings beforehand. See p.28 “NIC
FAX Initial Settings”.
You need to register this machine
by I/O device settings for Scan-
Router V2 Lite/Professional.

The setup procedure for ScanRouter
V2 Professional should be performed
according to the instructions de-
scribed in the "ScanRouter V2 Profes-
sional Setup Guide". However, the
procedure described under "For a De-
vice for Fax Delivery using RS232" in
the Setup Guide is not necessary for
this machine. This is because the ma-
chine transfers the received fax docu-
ments to ScanRouter V2 Professional
server via a network.

❒ To use ScanRouter V2 Profession-

al, settings must be made by a cus-
tomer engineer. Contact your
nearest dealer.

❒ You may need to perform the pro-

cedure described under "For a De-
vice for Fax Delivery using RS232"
in the Setup Guide depending on
the make of fax machine used with
NIC FAX for sending and receiv-
ing fax documents with a Scan-
Router V2 Professional server.

To deliver fax documents, you need
to make settings for transferring all
received documents to the ScanRout-
er V2 Professional server using the
NIC FAX Forwarding function. Fol-
low the steps below to make the set-
tings.

❒ If the document delivery was not

successful, NIC FAX prints out a
Communication Failure Report as
well as the document, and then
clears the document data from
memory.

AAAA

{{{{User Tools}}}} key.

The User Tools main menu ap-
pears.

❒ Start this procedure when the

standby display is shown on the
display. If the standby display is
not shown, make it reappear.
See Chapter 1 "Standby Dis-
play", Basic Features.

ZHMS130E