Preh mci touchkey 부록 매뉴얼
PrehKeyTec GmbH
TK-TechDoc_RevB_en.doc - 2008-07-31
Page 32/40
Configuring the flash memory using iLCD Setup
The most recent version of this software (iLCD Setup) can be downloaded from this
location:
How it works
This program is used to load graphics
into the flash memory of the TouchKey.
In order to load graphics, start by
selecting "setup" as shown in the image
on the right.
One can read out the actual graphics that are stored in the TouchKey using "Read
Flash". Selecting "Edit->Graphics" brings up the image below.
An existing graphic is selected using "Image
Index".
"New" creates a new graphic. If this is
selected a new dialogue windows opens up
from which the user can select the graphic to
be used.
Using "Remove" deletes the selected
graphic.
"Close" ends the configuration process.
Afterwards the new configuration is written in
the TouchKey’s memory with "Write Flash".
One could "Save" this configuration for
usage in another TouchKey. The saved file
can be edited again by going through the
first steps once more.
Index".
"New" creates a new graphic. If this is
selected a new dialogue windows opens up
from which the user can select the graphic to
be used.
Using "Remove" deletes the selected
graphic.
"Close" ends the configuration process.
Afterwards the new configuration is written in
the TouchKey’s memory with "Write Flash".
One could "Save" this configuration for
usage in another TouchKey. The saved file
can be edited again by going through the
first steps once more.