ONKYO TX-SA806 사용자 가이드
101
If you’ve connected your Zone 2 speakers to an amp with
no volume control, set the “Zone2 Out” setting, respec-
tively, to “Variable” so that you can set the zone’s vol-
ume, balance, and tone on the AV receiver/AV amplifier.
no volume control, set the “Zone2 Out” setting, respec-
tively, to “Variable” so that you can set the zone’s vol-
ume, balance, and tone on the AV receiver/AV amplifier.
Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
Setting the Zone2 Out
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
lowed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [
q]/[w] but-
tons to select “7. Hardware
Setup”, and then press [ENTER].
The “Hardware Setup” menu appears.
Setup”, and then press [ENTER].
The “Hardware Setup” menu appears.
3
Use the Up and Down [
q]/[w] but-
tons to select “2. Zone2”, and
then press [ENTER].
The “Zone2” menu appears.
then press [ENTER].
The “Zone2” menu appears.
7. Hardware
Setup
1. Remote
Control
2. Zone2
3. Tuner
4. Analog
3. Tuner
4. Analog
Multich
5. HDMI
7–2. Zone2
Powered Zone2
Zone2 Out
Zone2 Out
Not Act
Fixed
4
Use the Up and Down [
q]/[w] but-
tons to select “Zone2 Out”, and
use the Left and Right [
use the Left and Right [
e]/[r]
buttons to select:
Fixed:
The Zone 2 volume must be set on
the amp in that zone.
the amp in that zone.
Variable:
The Zone 2 volume can be set on
the AV receiver/AV amplifier.
the AV receiver/AV amplifier.
5
Press the [SETUP] button.
The setup menu closes.
The setup menu closes.
TX-SR806_En.book Page 101 Monday, August 4, 2008 10:25 AM