Samsung dvd-v940 지침 매뉴얼
ENG-19
Using the G-CODE Feature
Before presetting your DVD-VCR:
◆
Switch on both the television and your DVD-VCR
◆
Check that the date and time are correct
◆
Insert the cassette on which the programme is to
be recorded (safety tab intact)
Up to six programmes can be preset.
1
Press the TIMER button.
Result: The TIMER METHOD is displayed.
Result: The TIMER METHOD is displayed.
2
Press the corresponding
,
❷
buttons, until the
G-Code option is selected.
3
Press the
❿
button to select G-Code.
Result: A message is displayed to allow you to
enter the G-Code code.
☛
If all six programmes have been set, the
message Timer is Full is displayed. Refer to
page 22 if you wish to cancel a preset recording.
4
Press the numeric buttons to enter the code
opposite the programme that you wish to record in
your television magazine.
opposite the programme that you wish to record in
your television magazine.
➢
If you wish to correct the G-Code code that
you are entering:
◆
Press the
➛
button until the digit to be
corrected is cleared
◆
Enter the correct digit
Standard
G-Code
Timer Method
G-Code
Code
Code : 0 - 9
Correct :
5
Press the OK button.
Result: The information concerning the programme
Result: The information concerning the programme
is displayed.
☛
When using the G-Code function for the first
time with stored stations, the programme
number flashes. This one time, you must enter
the station number manually by pressing the
time with stored stations, the programme
number flashes. This one time, you must enter
the station number manually by pressing the
,
❷
buttons. Refer to the following page if:
◆
The programme number or times flash
◆
You wish to modify the programme
6
If the programme and times are correct, press the
RETURN button.
RETURN button.
7
Press the STANDBY/ON button to activate the timer.
8
Refer to page 21~22 if you wish to:
◆
Check that your VCR has been programmed
correctly
correctly
◆
Cancel a preset recording
☛
The numbers next to each TV programme listing
are G-CODE code numbers, which allow you to
programme your videorecorder instantly with the
remote control. Tap in the G-CODE code for the
programme you wish to record.
are G-CODE code numbers, which allow you to
programme your videorecorder instantly with the
remote control. Tap in the G-CODE code for the
programme you wish to record.
™ G-CODE is a trademark of Gemstar Development
Corporation. The G-CODE system is manufactured under
licence from Gemstar Development Corporation.
licence from Gemstar Development Corporation.
00374R DVD-V940K/XSA-ENG 5/6/04 11:34 AM Page 19