OEM ps-615 설치 설명서
Rear View of Speaker Assembly
Installation of 15° Angled LCRS Ceiling Speakers
1. Check ceiling area for concealed obstructions such as wiring, plumbing, heating ducts, etc.
2. Use a “stud finder” to locate positions of joists or rafters. Make sure that your intended locations for your
speakers are unobstructed and that the holes will be at least 1 inch away from joists or rafters.
3. Use the supplied compass or cut-out template/paint mask to draw a circle with the diameter that corresponds
to the model of your speaker on the chart below, and carefully cut out the hole.
4. Remove the grille from the speaker assembly using the included grille remover tool.
5. Before installation, turn the “Angle Lug Installation Clamps” (Item A) so they are positioned as in the image
below. This way, they will clear the cut-out hole for installation.
6. Prior to inserting the speaker assembly into the cut-out hole, attach speaker wires. Make sure to observe
polarity (the “+” and the “-”). Speakers wired out of phase will exhibit an apparent loss of bass response.
The wires will be held in place by the “Spring Clip Terminals” (Item B). Wires should be stripped about 1/2".
The wires will be held in place by the “Spring Clip Terminals” (Item B). Wires should be stripped about 1/2".
7. Insert the speaker assembly into the hole and orient it so that it is angled toward the listening area. A clear
plastic template is included to precisely align the direction of the speaker. The template must be removed
before the speaker is operated.
before the speaker is operated.
8. Begin to tighten installation screws. As you start to turn each screw, the “Angle Lug Clamps” will rotate
outward to engage ceiling material (Item C). CAUTION: DO NOT OVER-TIGHTEN THE CLAMPS. Too
much torque may snap off the lug, causing the speaker not to seat securely. A snug fit is all that is necessary
to assure proper performance.
much torque may snap off the lug, causing the speaker not to seat securely. A snug fit is all that is necessary
to assure proper performance.
9. If speaker assemblies are to be painted, either before or after installation, use the paint masking template
(cardboard disc) to cover the speaker driver(s) to prevent damage. DO NOT TRY TO PAINT THE GRILLE
AND FRAME
ASSEMBLY TOGETHER. The grille should always be painted separately. Use thin coats taking care not to
block perforations with excessive paint.
AND FRAME
ASSEMBLY TOGETHER. The grille should always be painted separately. Use thin coats taking care not to
block perforations with excessive paint.
10. Your speaker includes a pivoting tweeter and it may be aimed to achieve even better imaging. Tweeter
output should be directed toward the typical listening position. USE CARE TO AVOID DAMAGING THE
DOME OF THE TWEETER DURING AIMING!!
DOME OF THE TWEETER DURING AIMING!!
Models
Mounting
Diameter
PS-615 LCRS
9 1/4"
PS-815 LCRS
11 1/2"
Mounting
Depth
5"
5 3/4"
OEM Systems Company, Inc.
www.oemsystems.com