OEM sc-602e 설치 설명서

 

1.  Check ceiling area for concealed obstructions such as wiring, plumbing, heating ducts, etc. 

2.  Use a “stud finder” to locate positions of joists or rafters.  Make sure that your intended locations for your speakers is 

unobstructed and that the hole will be at least 2 inches away from joists or rafters. 

3.  Use the supplied compass or cut-out template/paint mask to draw a circle with the diameter that corresponds to the model 

of your speaker on the chart below, and carefully cut out the hole. 

4.  Remove grille from speaker assembly using included grille remover. 

5.  Before installation, turn the “Angle Lug Installation Clamps” (Item A) so they are positioned as in photo below.  This way, 

they will clear the cut-out hole for installation. 

6.  Prior to inserting speaker assembly into cut-out hole, attach speaker wires.  Make sure to observe polarity (the “+” and 

the “-”).  Speakers wired out of phase will exhibit an apparent loss of bass response.  The wires will be held in place by 
the “Spring Clip Terminals” (Item B).  Wires should be stripped about .25".  Tinning of wire ends will assure a trouble free 
installation, but is not necessary. 

7.  Single Point Stereo models have two sets of input terminals.  Each speaker location should be wired with a total of four 

speaker wires.  Attach the pair of wires carrying the Left Channel signal to one set and attach the pair carrying the Right 
Channel to the other.   

8.  Insert speaker assembly into hole and begin to tighten installation screws.  As you start to turn each screw, the “Angle 

Lug Clamps” will rotate outward to engage ceiling material (Item C).  CAUTION:  Do not overtighten the clamps.  Too 
much torque may snap off the lug, causing the speaker not to seat securely.  A snug fit is all that is necessary to assure 
proper performance. 

9.  If speaker assemblies are to be painted, either before or after installation, use the paint masking template (cardboard 

disc) to cover the speaker driver(s) to prevent damage.  DO NOT TRY TO PAINT THE GRILLE AND FRAME ASSEMBLY 
TOGETHER.  The grille should always be painted separately.  Use thin coats taking care not to block perforations with 
excessive paint. 

9.  Your speaker includes a pivoting tweeter and it may be aimed to achieve better imaging.  Tweeter output should be 

directed toward the typical listening position.  USE CARE TO AVOID DAMAGING THE DOME OF THE TWEETER 
DURING AIMING!!

 

SC-600 
SC-602 E 
SC-620 KE 
SC-622 K 

7 3/8" 

SC-800 
SC-802 E 
SC-820 KE 
SC-822 K 

8 5/8" 

SC-502 E 
SC-520 KE 

6 1/2" 

OEM Systems Company, Inc. 

(775) 355-0405     

●

     (800) 291-0561 FAX 

www.oemsystems.com      

●

     info@oemsystems.com  

Rev. B