Bunn smartwave aps 사용자 가이드
Page 12
Remove sprayhead by
turning counterclockwise
turning counterclockwise
DELIMING
Bunn-O-Matic recommends deliming your coffee brewer periodically. The actual frequency of deliming de-
pends on the mineral content of the water you use. NOTE: In hard water areas, this may need to be done daily.
It will help prevent liming problems in the brewer and takes less than a minute.
pends on the mineral content of the water you use. NOTE: In hard water areas, this may need to be done daily.
It will help prevent liming problems in the brewer and takes less than a minute.
Follow these simple steps:
1. Unplug the brewer and
1. Unplug the brewer and
let it cool down before
proceeding.
proceeding.
2. Remove the brew funnel.
3. Remove the sprayhead by
3. Remove the sprayhead by
turning it to the left with
your fi ngertips and set it
aside.
your fi ngertips and set it
aside.
4. With the sprayhead
removed, insert the
deliming spring (pro-
vided) all the way into the
sprayhead tube. When
inserted properly, no
more than two inches of
spring should be visible.
Saw back and forth fi ve
or six times. Remove the
spring.
deliming spring (pro-
vided) all the way into the
sprayhead tube. When
inserted properly, no
more than two inches of
spring should be visible.
Saw back and forth fi ve
or six times. Remove the
spring.
5. Check the holes in the
sprayhead. If plugged by
lime, they may be cleared
using a toothpick. Rinse
the sprayhead with water
before reinstalling it.
lime, they may be cleared
using a toothpick. Rinse
the sprayhead with water
before reinstalling it.
6. Reinstall the sprayhead
by turning it to the right.
7. Plug in the brewer and
allow the water to reheat
before using.
before using.
FIG 9
40410 092407
Keep vent hole
clear of debris
FIG 10
Twist deliming spring
while pushing in