Avaya P550 사용자 설명서

Configuring the Cajun P550 Switch (Layer 2 & Layer 3)

Cajun P550/P220 Switch Operation Guide 

 3-31

To configure your switch as an IP/IPX router, you must first configure your Cajun switch 
with the following hardware:

❒ Layer 3 supervisor module (mandatory)

❒ Layer 3 media modules (optional) including:

•

2-Port Gigabit Ethernet module

•

10-Port 100-Base-F module

•

12-Port 10/100-Base-T module

The Cajun P550 Switch with Integrated Routing combines scalable wire speed IP Layer 3 
switching (routing) with 10/100/1000 Ethernet Layer 2 switching (bridging) in a 
high-capacity chassis-based system. The product emphasizes traditional, 
standards-compliant IP operation and ample capacity to avoid bottlenecks. 

For more detailed information on Cajun P550 Switch routing operations, refer to 
“Routing with Layer 2 and Layer 3 Modules”, in Chapter 1.

The configuration process for the Cajun P550 Switch with integrated routing has the 
following minimum requirements for using IP routing:

❒ IP routing must be globally enabled.

❒ At least one routing protocol must be enabled (RIP, OSPF) if communication 

between routers is necessary.

❒ Determine which interfaces need to have IP routing enabled.

❒ If you plan to expand your current network, create VLANs (subnets) to address 

your network configuration.

❒ Assign an IP address, subnet mask, routing protocol, and multicast routing protocol 

to each IP interface you configure.

This section provides an overview of the LAN router configuration operation. For more 
information on these configuration steps, see the sections referenced after each step.