Avaya a500 사용자 가이드
Configuring the Cajun A500 Network
Cajun A500 ATM Switch User Guide
3-3
Bringing the ATM Port Down
To bring an ATM port down:
1. In the ATM Switch A500 section of the Web Agent window, select ATM Ports,
then select Configuration. The ATM Port Configuration window opens.
2. Select down in the Admin Status column for the port you want to bring down.
3. Click Apply to save your changes, or Cancel to restore previous settings.
To bring an ATM port down using the CLI:
1. In the ATM Switch A500 section of the Web Agent window, select CLI. A shell
window opens.
2. Execute the
admin downInterface
command from the Cajun A500s console. For
Configuring/Modifying the Link Type
You can then proceed to configure the link type for the port. If you are unsure of which
link type to use, refer to the section "Guidelines for Determining the Link Type". All
ports are configured in Auto Mode running on VPI 0 and are in the
admin up
state. This
means that as long as the box connected to the A500 supports ILMI, the ports are all
"plug and play".
PNNI does not come up and run unless the box has been configured with a valid IP
address. Therefore, all boxes in a network of A500s must have their IP addresses
administered and then they must be rebooted.
To configure/modify the link types for ATM port:
1. In the ATM Switch A500 section of the Web Agent window, select ATM Ports,
then select Configuration. The ATM Port Configuration window opens.
2. Click on the port you want to modify. The Protocol Configuration Table window for
that port opens.
3. Click Modify
. The Modify/Add Protocol Configuration Table window for that
port opens.
4. Enter the information for the VPI, Admin Status, config, Ilmi, cell rate, and
max vci.
5. Click Apply to save your changes, or Cancel to restore previous settings.