Avaya P550 참조 가이드

OSPF

10-10

 Cajun P550/P220 Command Line Interface Reference Guide

 *

    "'

To define an OSPF virtual link, use the area virtual-link router configuration command 
with the optional parameters. To remove a virtual link, use the no form of this 
command.

 

area <area-id> virtual-link <router-id> [hello-interval 

<seconds>] [retransmit-interval <seconds>] 

[dead-interval <seconds>] [{authentication-key <key> | 

message-digest-key <key-id> md5 <key>}]

[no] area <area-id> virtual-link <router-id> 

[hello-interval <seconds>] [retransmit-interval 

<seconds>] [dead-interval <seconds>] 

[{authentication-key <key> | message-digest-key <key-id> 

md5 <key>}]

area-id

IP address that represents the area-id for the system. 

router-id

Router ID associated with the virtual link neighbor. 
The router ID appears in the show ip ospf display. It 
is internally derived by each router from the router's 
interface IP addresses. This value must be entered in 
the format of an IP address. There is no default.

hello-interval <seconds>

Time in seconds between the hello packets that the 
Cisco IOS software sends on an interface. Unsigned 
integer value to be advertised in the software's hello 
packets. The value must be the same for all routers 
and access servers attached to a common network. 
The default is 10 seconds.