Avaya P550 참조 가이드
`~àìå=mRRMLmUUM=pïáíÅÜ=^qj=`if=réäáåâ=oÉÑÉêÉåÅÉ=dìáÇÉI=sÉêëáçå=NKN==
`~àìå=^qj=réäáåâ=`if=`çãã~åÇë
==============NJPV
ëÉí=äÉÅ=EíêáÖÖÉêJÅçìåíF
`çãã~åÇ=jçÇÉ
Configuration
aÉëÅêáéíáçå
Set the count to determine the frame rate at which the LEC attempts
to resolve an unknown destination MAC address to a data direct
VCC.
to resolve an unknown destination MAC address to a data direct
VCC.
* Note: You must disable a LEC each time you make a change to
the configuration. After you make configuration
changes, you must enable the LEC in order for the
changes to take effect.
changes, you must enable the LEC in order for the
changes to take effect.
póåí~ñ
set lec <lecID> trigger-count
<trigger-count-value>
q~ÄäÉ=NJPNK==m~ê~ãÉíÉêëI=hÉóïçêÇëI=^êÖìãÉåíë
p~ãéäÉ=lìíéìí
This example sets the trigger count for LEC 2 to a programmed time
interval of 15.
interval of 15.
ATM(configure)# set lec 2 disable
LEC 2 has been disabled
ATM(configure)# set lec 2 trigger-count 15
LE ARP Trigger Count 15 has been set for LEC 2
ATM(configure)# set lec 2 enable
LEC 2 has been enabled
Name
Definition
lecID
The LEC identifier. The range of values is:
Minimum = 1, Maximum = 128.
Minimum = 1, Maximum = 128.
trigger-count-value
The LE ARP trigger count measured in
seconds. The range of values is: Minimum = 1,
Maximum = 20.
seconds. The range of values is: Minimum = 1,
Maximum = 20.